Daystar KG09114 Instrukcja Użytkownika Pobierz pdf

TOOLS NEEDED

Floor Jack X 1

Jack Stands X 2

Puller Tool X 1

Hand Tools

18mm socket and wrench

BILL OF MATERIALS

P11322 X 2 Torsion Keys

P20081 X 1 Instructions

P11412 X 2 Lower shock extenders

IMPORTANT: The net amount of ride height increase de-

pends upon the age and use of the vehicle, wheel offset, and

numerous other factors. Stated torsion bar ride height in-

creases are based upon factory specifications. If the torsion

bars were “cranked up” at some point in the past, expect a

corresponding reduction in overall height increase with the

new torsion keys. Note that torsion bars, like any other

spring, are subject to fatigue and sagging over time. Also,

torsion bars have different ratings depending on how the vehi-

cle was equipped from the factory. In some cases, installing

heavier rated bars (which can be purchased from a dealer)

may be the only solution to regaining ride height lost from

adding heavy aftermarket accessories, such as a winch

bumper or snow plow.

NOTE: Various types of puller tools are available, however, due to the

extreme loads present in four-wheel drive suspension systems, we have

found the two-jaw style tool that clamps to the crossmember tends to slip

and damage the crossmember. A C-clamp style puller tool is preferred

and available through tool companies such as OTC and Kent Moore.

WWW.DAYSTARWEB.COM

Instruction Sheet P20081

2007 Daystar Products International Inc.

www.Daystarweb.com

Tech Support Contact Info

[email protected]

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

KG09114

1999-07 2500/3500 HD 8 LUG 4WD

TORSION BAR LEVELING KIT

1 2 3 4

Podsumowanie treści

Strona 1 - TORSION BAR LEVELING KIT

TOOLS NEEDED Floor Jack X 1 Jack Stands X 2 Puller Tool X 1 Hand Tools 18mm socket and wrench BILL OF MATERIALS P11322 X 2 Torsion Keys P20081 X

Strona 2 - Product Use Information

Thank you for choosing Daystar Products Daystar recommends a certified technician install this system . In addition to these instruction , professio

Strona 3

9. Using extreme caution, tighten the puller tool enough to take the load off the adjuster bolt. Remove the adjuster bolt and nut block, then unlo

Strona 4 - Installation steps

1. Place the vehicle on a level surface. Prior to beginning, record ride height on each side of the vehicle by measur-ing from the center of the s

Komentarze do niniejszej Instrukcji

Brak uwag

Daystar KG09114 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Do samochodu Daystar KG09114. Daystar KG09114 User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Do samochodu Daystar KG09114